Menu Disabled Black Particles, Flakes, Sparklies - Colloidal Silver

Healing Clays of the World ~ Illite, Bentonite, Montmorillonite - Eytons' Earth


- Tell a friend about this page/post @ Eytons' Earth -

Eytons' Earth: Natural & Alternative Medicine
Discussions on Natural & Alternative Medicine
 
 FAQFAQ   SearchSearch   UsergroupsUsergroups      
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in
Register 

Black Particles, Flakes, Sparklies - Colloidal Silver

 
Post new topic   Reply to topic    Eytons' Earth: Natural & Alternative Medicine Forum Index -> Colloidal Silver Generators
Author Message
Foggy_Notion



Joined: 01 Nov 2008
Posts: 1

PostPosted: Sat Nov 01, 2008 1:03 am    Post subject: Black Particles, Flakes, Sparklies - Colloidal Silver Reply with quote

Hi all, hope this finds you in good health.

I purchased a generator and it worked fine.
I would only use it about once a week though.
It worked fine for 5 months.

One time I went to use it with the same distilled
water I always used, same silver wire.

And when I returned little black things were floating
in the water.

I threw it out and tried again and again, with different
water and got the same results.

Does anyone know why this is happeneing?

Because this makes me paranoid as can be
because it coincided with me becoming an
activist, bad mouthing the oil compnaies,
showing people how to make free electricity
using old Tesla patents, etc...

Well, they're powerfil people and I wouldn't
put it past them, if they feel someone was
stepping on their toes. Wait now I sound like
a nut, ha ha ha.

Have these black floating flakes in the water
occured with anyone else?

Thanks.





.
Back to top
eytonsearth
Site Admin


Joined: 31 Dec 1969
Posts: 226
Location: Las Vegas, Nevada

PostPosted: Mon Dec 01, 2008 10:01 am    Post subject: Reply with quote

Greetings,

It is most likely that your silver electrodes are degrading. Any jagged edges ( even ones so small that you can't really see them ) cause an uneven pull of silver ions off of the electrode as the electrons are travelling between both electrodes.

This eventually causes very obvious flaking.

With basic colloidal silver generators, it is very important to buff the electrodes between batches in order to minimize the amount of agglomerated silver ( "sparklies", flakes, etc. ) deposited into the distilled water.

Try to be certain that the electrodes are parallel to each other when in the water. This will help minimize the problem.

Of course, the bottom of the silver electrode "rods" are always a problem area. That is why silverpuppy.com switched to looped electrodes. You could always buy the looped silver electrodes from Ken at silverpuppy.com and tyr to rig them to work with the unit you purchased.

I hope this helped!

Kind Regards,

Jason
_________________
~ Jason

Learn about the benefits of Colloidal Silver & ozone therapy & ozone generators.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    Eytons' Earth: Natural & Alternative Medicine Forum Index -> Colloidal Silver Generators All times are GMT - 7 Hours
Page 1 of 1

 



- Tell a friend about this page/post @ Eytons' Earth -

Powered by phpBB © 2001, 2005 phpBB Group

[ Healing Clay Information ] [ Colloidal Silver News & Information ] [ Ozone Generators & Therapy Information ]
Hosted by Av Web: Las Vegas SEO & Website Design
All Content Copyright 2007 Eytons' Earth